Articles on: Maintenance & Repairs

OneQuad-EX2S - Pre-ride checklist

Loose Parts
Check and secure all fasteners before every ride. Make sure steering stem clamp bolts are locked properly in place. There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check.
Brake
Check the brake for proper function. When you squeeze the lever, the brake should provide positive braking action.

Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are rare, it is possible for an aggressive driver to bash into a curb or wall and wreck and bend or break a frame. Get in the habit of inspecting yours regularly.

Tire Inflation
Periodically inspect the tires for excess wear, and regularly check the tire pressure and re-inflate as necessary. If you get a flat tire, the inner tube can be patched or a new tube can be purchased from an authorized repair shop

Safety Gear
Always wear proper protective equipment such as an approved safety helmet, elbow pads and knee pads. Always wear shoes (lace-up shoes with rubber soles), never drive barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels, motor and drive system

Charging the Battery
Your electric mini quad may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
Initial charge time: 12 hours
Run time: up to 45minutes
Average battery life: 250 charge/discharge cycles
Recharge time: Always remember to turn the power switch off and recharge for at least 9 hours after each use.
When a vehicle is not in regular use, recharge the battery at least once a month until normal use is resumed. If you have left the power switch on or your product has not been charged for a long period of time the battery may reach a stage at which it will no longer hold a charge.

Warning: Failure to recharge the battery at least once a month may result in a battery that will no longer hold a charge. The battery is not under warranty.

WARNING: Always disconnect your electric mini quad from the charger before cleaning with liquid.

The charger has a small window with two LEDs to indicate the charge status. Red LED means the battery is in charge and Green LED means the battery is fully charged. Chargers hav
e built-in over-charge protection to prevent the battery from being overcharged. Be sure to properly align the groove on the charger input port with the corresponding socket on the Mini Quad and tighten threads; otherwise, no charging action will occur.

Updated on: 05/11/2021

Was this article helpful?

Share your feedback

Cancel

Thank you!